AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Gps tracks manual different gps settings12/29/2023 The AVL Server Settings section is used to configure the main parameters of data sending to an AVL server. The AVL page is used to set up GPS data sending to an AVL server. Includes digital input #2 state in GPS data package to be sent to server. Includes digital input #1 state in the GPS data sent to server. Includes analog input state in GPS data package to be sent to server. Includes GSM signal strength information in the GPS data sent to server. The TAVL Settings section is used to select which data will be sent to the TAVL server: IP address or hostname of the HTTP/HTTPS server. Turns data sending to an HTTP/HTTPS server on or off. The HTTPS/HTTP Server Settings section is used to enable GPS data sending to an HTTP or HTTPS server: The HTTPS page can be used to configure data sending to an HTTP(S) server. Overall satellite data (used in BeiDou sentences). GNSS position fix from more than one constellation (e.g., GPS + GLONASS).ĭetailed satellite data (used in BeiDou sentences). Recommended minimum specific GPS/Transit data. Track made good and speed relative to the ground. NMEA sentence collecting frequency in seconds. NMEA sentence forwarding frequency in seconds.Įnables collecting for the adjacent NMEA sentence. The figure below is an example of the NMEA sentence settings section and the table below provides information on the fields contained in that section:Įnables forwarding for the adjacent NMEA sentence. The NMEA sentence settings section provides the possibility to configure which NMEA sentences will be forwarded or collected and at what frequency. This field becomes visible only when NMEA collecting is enabled. Location of the file where NMEA sentences will be stored. Turns NMEA sentence collecting on or off. The figure below is an example of the NMEA collecting section and the table below provides information on the fields contained in that section: The NMEA collecting section is used to enable NMEA sentence gathering and storing. This field becomes visible only when the selected memory type is "flash". Location of the file where NMEA forwarding cache information will be stored. Maximum amount of NMEA sentences that will be saved in the cache before older entries are deleted and replaced by new ones. Selects which type of memory will be used for storing NMEA forwarding cache. This section is used to select the memory type where the cache will be stored and the maximum amount of data that will be saved: The router caches NMEA forwarding information if NMEA forwarding is enabled. Protocol that will be used to send NMEA dataĬontain active session with a remote server Port number off the server to which NMEA data will be forwarded ![]() IP address or hostname of the server to which NMEA data will be forwarded The figure below is an example of the NMEA forwarding section and the table below provides information on the fields contained in that section: The NMEA forwarding section is used to configure and enable NMEA forwarding. ![]() The NMEA page is used to configure settings related to NMEA sentence collecting and forwarding. Therefore, if you make changes to these options and save them, the router will lose cellular connectivity for about 30 seconds. *Changing these options requires a modem reboot. Turns support for BeiDou satellites on or off. Turns support for Glonass satellites on or off. Turns support for Galileo satellites on or off. The figure below is an example of the General page and the table below provides information on the fields contained in that page: The router will not be likely to obtain a GPS fix otherwise. It is very important to attach the GPS antenna on the router and place it outside (not inside of a building). This page is an overview of the GPS service in _GPS#Map|Map]] page in order to see if the router has obtained a GPS fix. The Global Positioning System ( GPS) is a space-based radionavigation system.
0 Comments
Read More
Leave a Reply. |